xcellent choice, lamp provides indication and nice slope for current rate.


"Ron(UK)" wrote in message
...
Sam Goldwasser wrote:
James Sweet writes:

wrote:
Thanks for looking.

How does one discharge a capacitor when working on a PCB, so that one
does not get electrocuted? Are there any other components that
maintain a charge after turning off power source. Thank you. please
answer to .
Usually just short it with a screwdriver. CRTs can store a charge too.

This is generally frowned upon both due to the pits it will produce in
the screwdriver, the noise, and potential damage to some types of
capacitors. See the info at the site below.


Rightly or wrongly, I use a 240volt BC pygmy lamp with two leads fitted
with prods soldered to the pads on the bulb. Works for me.

Ron(UK)
--
Lune Valley Audio
Public Address Systems
Hire Sales Maintenance
www.lunevalleyaudio.com