On Feb 24, 12:31 pm, "Eigenvector" wrote:
I'm thinking that at this point I'll need a plumber to do this, but wanted
to toss this idea out first.

I'm trying to replace the galvanized hot water pipe to my kitchen - it's
rusted shut as galvanized is want to do over time. Anyways, the pipe is in
the crawlspace, elbows into the sill plate, elbows vertical in the wall,
then elbows out of the wall inside the sink cabinet. The sill plate hole is
filled with concrete.

I just can't see myself getting that pipe out of there without major
construction. The best bet I have is to cut the pipe at the sill plate then
pull it out of the wall under the cabinet. Maybe do-able but I'll never be
able to run the new pipe using that same route. I just can't see it
happening. So here's what I was wondering. Would it be kosher to simply
drill a hole in the floor of the cabinet, through the underlayment and avoid
all those nasty joints? That way it's a simple down, elbow to the source.

It's either that or I bring in a professional. Nothing wrong with bringing
in a professional of course, but I really would like to do it myself so long
as it's feasible.

Buffalo ny: you will enjoy the results of upgrading from low water
flow providing you have your water main bringing in great water flow
to the basement washtubs. no S traps for drains. no water pipes
allowed in outside walls. check your local permit office to see what's
allowed or required to be used in your area. we prefer over sized
supply lines [one inch not 3/4" main] and water meters at replacement
time, to better enjoy full water flow at each fixture.