The wire was running from behind a finished wall (from the finished
side of the basement) to the switch;
however, between the switch and the place I was placing the outlet,
the wire went back behind the wall.


On Feb 20, 7:09 pm, "DerbyDad03" wrote:
On Feb 20, 6:16 pm, "Paul" wrote:



hello - I amaddinga couple of outlets in my unfinished basment,
something I have done before (though never in this house - new (1985)
house)
However, with this circuit, when I add anoutlet(black/white/ground
NM), and I test theoutletwith circuit tester , I get "hot/neutral
reversed".
When I flip the switch that I believe is at the end of this circuit,
(this switch controls an overhead light, and only has cable going into
it) my circuit tester (on my "new"outlet) changes from "hot/nuetral
reversed" to "hot/ground reversed". As far as I know, there is nothing
(outlet, junction box, switch) between my newoutlet, and the wall
switch.
The light switch has a black wire, and white wire that has been
painted black going in, as well as bare ground.
Any suggestions as how to wireoutlet, re-wire wall switch?
Many thanks,
-paul

Where did you get the wires that you connected to the new outlet too?