Will this fit tighten with glue?
On Feb 15, 1:40�pm, "Toller" wrote:
I am using some coat pegs that measure 0.493". *That is a pretty sloppy fit
in a 0.500" hole, but other than hoping I can find an undersized drill bit,
I am not sure what to do about it.
Presumably the glue will swell the pieces a bit; but will it be enough for a
secure installation?
The pegs are a bit too expensive to waste one on a test.
If you are able to - put a small brad in the hole such that it is
driven into the peg when you drive the peg home. With some glue in the
hole of course.
Bob AZ
|