Dr. Deb wrote:
I bought a Jet 1442 about a year or so ago and, for the most part have been
pleased with it. I turned the handled for the Reeves Drive around to get
it out of the way and have replaced the bearing on the head shaft (it
sounded noisy, but was a loose pulley and not the bearings), but other than
that done nothing, until this past weekend.

Now for the question. The Reeves Drive has quite a bit of travel left when
you put it in the last detent (450 RPM). The belt got stuck in the pulley
and did an auto adjust to about 2,000RPM, instead of the expected 450RPM,
to the determent of a floresant tube when a piece of bark hit it. So,
while I had it down getting the belt unstuck, I decided to drill two more
detents on the slow side of 450. Seems to work great (I have not figured
out exactly what speeds I now have yet - I had turning to do!) but it seems
to have slowed the lathe down without any loss in power. Is there any
reason I should not run at those new lower speeds?

Deb
Are you sure the belt hasn't worn/stretched? As long as both pulleys are
engaging the belt it should work fine. I wore out a couple of belts on
my Delta and finally put a link belt on it and it ran quieter and never
showed any wear as long as I used it. (I have a newer lathe now, without
the Reeves drive).

--
Gerald Ross
Cochran, GA

Animal testing is a bad idea: they get
all nervous and give wrong answers.