In article , Mark Lloyd wrote:
On Fri, 09 Feb 2007 11:02:27 GMT, (Doug Miller)
wrote:

In article om,
wrote:
I need to install a used hot water tank into an existing home that had
the tank already removed. So looking at the existing hookup is
impossible since no tank is there.

Two of the wires are hot, so I will simply attach 110V to each wire,
of course being on a separate leg off the box. Where does the neutral
wire attach? To the ground on the tank?

Assuming it's a 240V water heater -- there is no neutral. The black and white
wires in the supply connect to the two hot leads on the water heater, and the
bare wire in the supply connects to the ground on the water heater.

That white is SUPPOSED to be red. White is meant to be used for
neutral. Someone's used the wrong cable and failed to make the white
as red.

In what sense is using 10/2 WG to wire a water heater "using the wrong
cable"??

--
Regards,
Doug Miller (alphageek at milmac dot com)

It's time to throw all their damned tea in the harbor again.