"bluechip" wrote in message
oups.com...
I have got one of those sectional concrete garages, where vertical
sections are bolted together to form the structure.
The whole garage is now leaning ever so slightly to the right such
that the up and over door is sticking and wont close properly
Whats the best way of getting this garage upright again?

There's no *best way* really.
One way could be...

Obtain some 8' concrete fence posts, about 4 should do, more if you can
afford to and have space.
Dig a hole about a foot in from the corners (outside) about 18" square by 3'
deep and then equi-space the other holes per post along the side that is
leaning away.
Either jack or winch the structure upright and temporarily secure at that
point.
Insert posts into holes as close to the sides as possible and concrete in,
tamping the mix down tight.
When set, bolt through the sides to the posts using ½" studding and large
washers where required. Packing out with thin timber may be required to keep
the gaps tight.
After all is set release the retainers and check vertically.
Tighten or replace any suspect existing bolts that hold it all together
inside.
Re-align door.