"Buck" wrote in message
...
"Buck" wrote in message
...
One of the springs is unwound but not broken. Looks like a the set
screws
came loose. I Googled for info & only found lots of stuff on how to
replace
the springs. Can I simply wind this spring back up? Should I unwind the
other first to make sure both springs are equal?
Thanks!
Ok, ok. Looks like it's unanimous. I saw the info at
http://www.truetex.com/garage.htm and being quite mechanically inclined I
thought I might give it a go. I called around - looks like it's cost me
$200 - 300. Strange though how the spring did not break, it just popped
off
the holder at the middle of the rod...
It's not that big of a deal if you have some common sense.
Go to
http://www.garagedoorsupply.com/tors...tallation.html and
start at step 5
Rich
http://www.garagedoorsupply.com