On Jan 29, 8:53 am, "Jeffy3" wrote:
On Jan 28, 1:47 pm, wrote:





On Jan 28, 1:27 pm, "Jeffy3" wrote:

On Jan 27, 2:18 pm, "Edwin Pawlowski" wrote:
ooglegroups.com...
?There are no screws on a compression fitting. Do you mean the nut?
if so,

put the nut over the tubing, slip the ferrule over the tubing and leave
about 1/4" showing. Slip that into the female end of the fitting and
tighten the nut.Thanks. I meant a compression nut. The compression nuts which came
with the kit had the ferrule already inside the nut. Should the nut
be able to completely screw onto the female end of the T fitting? I
can't get it on more than halfway, and there's a slow drip coming out
of the other side of the nut (not the side closest to the T fitting).
What is normal cause of a drip? Not tight enough? Too tight?
Ferrule in wrong place?The nut should go on most, or all of the way. The ferrule should be
seperate from the nut. As Edwin stated, the nut goes on the tubing,
then the ferrule, and then you insert the tubing as far as it will go
into the fitting. While keeping some pressure on it to make sure it
stays all the way in, tighten down the nut, which compresses the
ferrule against the tubing. If you botched it, easiest thing is to
cut of the end of the tubing, get a new ferrule and redo.Are there alternate names for these ferrules? I don't recall seeing
anything by that name in the hardware store where the compression nuts
were.- Hide quoted text -- Show quoted text -



They may call them compression sleeves. Regardless of what they call
them, they should be located with the compression fittings and very
obvious. You get several of them in a small bag.