i think its the horiz circuit.


When i press power, pin26 of U1001 jumps to about 8.6 volts. holds it for
about 3 to 5 seconds, and drops back down. jumps back up each time i press
power.

there is NO drive on the HOT. on any attempt. even on plugin. no drive.
somethings up.




"Mike" wrote in message
...
Got this set, it would turn on and fire HV for a second, then shut back
down. it wont do it anymore, only did it one time.


I monitored C4118 while pressing the button, it would start off at 13.1
volts, and drop down to about 5 volts. when power button was pressed.


I then replaced CR4118, and replaced 2 caps in the IC chip of the power
supply. the main B+ at standby levels is about 143vdc. the 15v standby is
about 13.3 still.


but this time, when you press the power button, OR perform the manual
power-on, bypassing the micro unit, the voltage doesnt drop anymore, but
the set still is dead. HOT is fine, chopper is running. I dont know what
to look for next.

however if i hold the board in manual power on, every once in awhile the
degauss relay would start clicking on and off a little bit, very faintly,
like a weak supply somewhere.

any ideas?