Phil L wrote:

You can buy gasket from any upvc manufacturer - if it's only for one window
they will probably give it to you but if they don't, it's cheap as chips
anyway...it's usually coated in an oil like substance - don't wipe this off
as it helps it to slide in with a bit of effort on your part, start in one
of the upper corners and insert it fully down one side, then across the
bottom, then up the other side and back across the top to where you started
(this way it's a continuous seal, apart from the top corner, where it's not
imperative) - then cut it off - don't try to cut it to size first, and make
sure you get a piece bigger than what you need.

Hi Phil,
Guess I was just being lazy. :¬)
I'll have to check the local UPvC mftrs.
I have fitted a few DG units in my younger days and remember that the
supplied gasket was a fair bit longer than rqd, but never trimmed any as
it would invariably shrink over the years.
:¬)

Cheers
Pete

--
http://gymratz.co.uk - Best Gym Equipment & Bodybuilding Supplements UK.
http://gymratz.co.uk/polar-heart-rate-monitors/ Polar HeartRate Monitors
http://fitness-equipment-uk.com - UK's No.1 Fitness Equipment Suppliers.
http://water-rower.co.uk - Worlds best prices on the Worlds best Rower.