On Sun, 21 Jan 2007 23:47:40 GMT, "Edwin Pawlowski"
wrote:


"CW" wrote in message
thlink.net...
If the tablesaw is not smooth enough, you need a different blade. If the
circular saw is not strait enough, you need to use a saw guide.


It also helps to have a good support on both in-feed and out-feed if the
panels are large.


This is the next step I need to tackle. Most the pieces are small
enough to handle, but a few are 5' long. Thought of running it onto a
saw horse, will look at it over next few days.