Here's why you don't put your fingers above the router bit
On Fri, 19 Jan 2007 22:43:17 -0500, "Stoutman" .@. wrote:
Was cutting a 3/16" wide dado in a piece of Lyptus using an Amana
upcut spiral bit. Was cutting 3/16 deep in half inch stock. Router
is a Porter-Cable 7518 in a lift.
The bit came through 1/2" stock during the a 3/16" dado and you never felt
or heard a difference as the bit was rising ??
This has happened to me before, but I can usually feel/hear the difference
as the router starts working harder.
No more than the usual variation I get from one piece of wood to the
other.
Glad you are ok.
Me too. Thanks.
|