"Ron(UK)" wrote in message
...
Arfa Daily wrote:


In that case, go for it. I would be interested to know how you get on
with such transpants, and which presets you ultimately find most
suitable. Also, how quiet they are in actual practical usage.

Arfa

I'm interested to know how the OP plans to reliably connect a standard
shaft to a preset, I`m presuming his idea of a preset and mine concur.

One other point, presents don`t normally come in log tapers, do they?

Ron(UK)

Hi Ron. That is a very good point, and one that I hadn't even considered
when thinking about his original plan to use these. If you look in the post
that started the thread, he says that he is intending using the presets that
you can get a 6mm shaft for that turns them into a ( semi ?? ) user
control - I'm sure you've seen the idea on stuff where there is an
adjustment that would be a good idea to have available to the user, but not
in a way that encourages him to *use* it. The shafts that I've seen usually
have a lightly splined finish so that they can be gripped, and a screwdriver
slot in the end. I think he intends to pass one of these through a panel
mount shaft bush, and then persuade the knob to fit.

Arfa