"John Rumm" wrote in message

My weapon of choice would be a Fein multimaster with a cranked eCut[2]
or segment blade - that will give a fine and controlled cut. Again use
some upturned flooring as a spacer - no need to adjust for the blade
kerf since the blades are so fine.


--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/

You have mentioned the Biscuit Jointer also as a suggestion,why would you
use this fein tool which is slow and cumbersome as to the BJ which can do it
in one cut practically ie position,plunge,finish.

The FM you have to move the tool along the job trying to keep moving the
blade along a straight line.
I reckon this FM is useful where laminate is being fitted as the BJ does not
go low enough for cutting the achitraves.