"PhattyMo" wrote in message
...
Dan wrote:
I was recently given a portable DVD player for signing up to DirctTV. I
didn't expect it to be the best one on the market (smallish screen for 1
thing) but I thought it would be good for watching a movie during
frequent 2 hour plane trips I have to take. Plays fine, decent picture,
BUT the batteries crap out after a little over 1 hour (you'd think at a
minimum the thing would be good for one 2 hour film). So I opened the
battery pack & as I suspected, found 7 NiMH AA cells, marked 1300 mah. I
see that NiMH AA's are available up to around 2700 MAH. Swapping out the
cells is straightforward, but I'm wondering if the current charger would
be up to the task of feeding them. Looks like a fairly decent circuit
(multiple ic's, anyway) which includes a thermistor taped to the cell
pack. Whether this is how the circuit senses a full charge or whether
it's an overheat detector, I don't know. But again, the circuit does
appear to be a bit more sophisticated than those I've seen for drills,
etc, which do rely on the crude temp method to indicate a full charge.
Might this charger be able to handle cells of 2X the capacity of those
the unit came with? How could I test this, short of actually buying &
installing the higher amp cells? A measure of charging current with the
present cells, maybe?

TIA

Dan


The charging circuit itself _probably_ limits the current to some "safe"
value,so there's _probably_ no worries about frying the
charger,overcharging the cells,etc.
It will just take 2x as long to fully charge..

Thanks for the replies, I'll give it a try.

Dan