In article ,
Owen Lowe wrote:
Years ago, a regular to this group, Lyn Mangiameli, discussed slow speed
sanding. After I tried it I was a convert - I now rarely sand above 500
rpm - and oftentimes it's much slower depending on the work diameter.
I'll see if I can look up the thread and post the link.
http://groups.google.com/group/rec.c...3d44827484e9de
1b?&hl=en
--
Owen Lowe
Northwest Woodturners
Pacific Northwest Woodturning Guild
___
Tips fer Turnin': Place a sign, easily seen as you switch on your lathe, warning you to remove any and all rings from your fingers. Called degloving, extended hardware can grab your ring and rip it off your finger. A pic for the strong of stomach: www.itim.nsw.gov.au/go/objectid/2A3AC703-1321-1C29-70B067DC88E16BFC/index.cfm
Besides, rings can easily mar the surface of a turning as you check for finished smoothness.