Stubby wrote:

I have a 3/4" Cu pipe carrying return water in my baseboard heating
system. It is install in a channel in the slab floor. I have exposed
about 4" of length and am pondering sawing the pipe. But there is no
room to sand it all the way around. There is only about 1/2" of space.

Can anyone tell me how to get the pipe prepared for soldering? TIA


Not nearly enough info, but you could make a loop of
"sandpaper" out of maybe a 2" wide strip.
Form the loop so that it looks like a "U" and slip
one end under the pipe. Work the sandpaper up and down.

If not that, then you'll have to make a better picture
of what you're doing.

Jim