Steve in Virginia wrote:
My F-I-L has a Kenmore DW which he rarely uses. He purchased it around
a year ago when he remodeled his kitchen. Recently,on one of the rare
occassions he decided to turn it on, there was a problem. Apparently,
the dedicated 15A circuit is pulling voltage lower than 120 VAC.
Obviously, the DW doesn't work. Before I go pulling the DW out so I
can trace out the voltage drop, any suggestions as to what might cause
a problem like that?

I haven't been over his house to check it out. I just got the news
over the phone Sunday night. My B-I-L looked at it but has no clue
and I don't know how the voltage drop was determined. Then my B-I-L is
no handyman. Actually, I'm genuinely surprised he didn't burn the
house down checking it out. This is a guy who needed to be told that
you can't solder a pipe with water in it! No, I'm not making this up.

Any ideas would be greatly appreciated.

Steve

Hi,
Infrequent use caused jamming of the motor?