On Mon, 04 Dec 2006 00:00:00 GMT, 46erjoe
wrote:

I just bought a new home in NE Pa. It's about 4 years old. Just inside
the kitchen coming in from the door of the attached garage is an
on/off switch with a bright red cover plate. I'm assuming it's the
safety switch for the furnace to turn it off in an emergency. The
furnace is gas/ho****er.

When the furnace is running and I flip the switch, nothing happens.
The furnace keeps running. I checked in the basement and just below
where the switchplate is located, exiting from the corner of the base
stud plate is about 10 feet of coiled 14/2 wire just hanging there. On
it in ink is written "furn safety". But it's not connected to
anything.

Was this an oversight on the part of the builder/electrician? Or did
it suddenly become a non-code item? I find it hard to believe than an
inspector would miss it.

If this must be hooked up, how do I go about doing it? Just finish the
run to the power near the furnace and splice it in so that power runs
to the furnace only when the switch is turned on and the circuit is
complete?

Or just forget the whole thing?

Thanks.
Can't you get hold of the seller? If no longer local, get the real
estate agent stirred up about a possible safety element.

Worst come to worst, is there some kind of municipal oversight
that can help you answer the q?