Gluing up a turning block
Toller wrote:
I am probably making too much out of this, but it is my first time and all
that.
I am gluing up a turning block; sandwiching spalted maple between wenge.
What glue to use? Is PVA adequate, or polyurethane, or epoxy?
Yesterday I turned a plate that was simply taped onto the faceplate; so I
expect PVA will do fine, but I would rather benefit from other's experience
than my own.
You're right, you're making too much of it. PVA is stronger than the
wood itself, especially when you have such a large glued surface.
DonkeyHody
"We should be careful to get out of an experience only the wisdom
that is in it - and stop there; lest we be like the cat that sits down
on a hot stove-lid. She will never sit down on a hot stove-lid
again---and that is well; but also she will never sit down on a cold
one anymore." - Mark Twain
|