Thread
:
Craftsman Garage Door Opener
View Single Post
#
7
Posted to alt.home.repair
Rich256
external usenet poster
Posts: 178
Craftsman Garage Door Opener
wrote:
I just saw an earlier post that outlines the same problem that I am
having. My garage door doesn't want to go down. It will start to
close, go down a few inches and then go right back up again. Once it
does this the lights will blink as if the sensors are obstructed yet
they are not. I have been careful to clean the sensors of any dirt,
cobwebs,etc. and I have made sure that there is nothing obstructing the
sensors as well. I have had this problem occaisionally in the past
couple of months but it seems to resolve itself on its own for no
apparent reason as if it has a mind of it's own. I believe that the
garage door is approx. 9-10 yrs old and I have an aluminum door.
One note to mention: About four months ago I closed the garage door
and the garage door buckled in the center due to an improper support on
the door that snapped. At the time, a technician came out and fixed
the door and adjusted all of the up-down balances and oiled the door.
Any help with this would be greatly appreciated!! :-)
Thanks!
Had a similar problem. After checking that the door moved easily by
hand I check the alignment of the sensors again. From what I could
determine they were just slightly off (or rather in). The movement of
the door was just enough to set them off. Did a bit of adjustment and
no more problems. Check the wire connections too. THey might be
breaking when the door moves.
Reply With Quote
Rich256
View Public Profile
Find all posts by Rich256