Bill wrote:
I just bought a 3/8" Lexan router plate which has been tapped for leveling
screws around the edges but is otherwise untouched. I am intending to hang
a Milwaukee 5625 from it, eventually using it to raise panels for cabinets
around the house & shop.

I am thinking that I should find the center of the plate, drill mounting
holes, put a 1/2" center cutting bit in the collet, mount the Lexan to the
router and plunge through it for the initial hole and then repeat the
process each time I need a bigger bit ... up to and including a ~3"
panel-raising bit.

All the while investing in additional router plates until I have one for
pretty much every diameter of router bit ever made. And changing the
router base nearly as often as I change bits (best argument I've ever seen
for long production runs).

I can see how this plan might be workable if I could just secure
renewable govertnment grants to buy the Lexan, but I doubt if it is the
best way to go with my pre-grant seed money.


Here is a sweet solution:
http://www.leevalley.com/wood/page.a...,43053&p=50264