Actually, if the area is only 1.5x2.5 ft, you could do it by hand, w/ lump
hammer and *good* chisel, w/ about 3 cases of beer.
Would also depend on how clean it peeled up. If you then had to go in
another 2-4" and repour, mebbe the demo hammer would still be best. Proly
about $40-50 to rent, $750 to buy--the Bosch.
--
Mr. P.V.'d (formerly Droll Troll), Yonkers, NY
Stop Corruption in Congress & Send the Ultimate Message:
Absolutely Vote, but NOT for a Democrat or a Republican.
Ending Corruption in Congress is the Single Best Way
to Materially Improve Your Family's Life.
entropic3.14decay at optonline2.718 dot net; remove pi and e to reply--ie,
all d'numbuhs
"Proctologically Violated©®" wrote in
message ...
Well, actually, I was a little confused, too.

Two strategies, likely both requiring a demolition hammer. Or a hand
hammer and chisel, and about 35 cases of beer.
W/ a wide chisel bit, hold the hammer as parallel to the floor as is
practical, and see if you can't just chip off the high spots level to the
rest of the floor.
Iffin yer *real* lucky, this will work.

If not so lucky, take same demolition hammer w/ a long narrow chisel bit,
chip out the whole raised portion an inch or two below the surface of the
existing floor, and re-pour.
They sell a cupla types of cement, one for thin pours (I think 2" or
less), and the other for thicker sections. Others here would know more
about that part.
But the more you chip out, the more work you make, and the more cement
you'll have to use.

With *real real* luck, that ledge was poured after the floor, and might
chip up real clean.
--
Mr. P.V.'d (formerly Droll Troll), Yonkers, NY
Stop Corruption in Congress & Send the Ultimate Message:
Absolutely Vote, for *Anyone BUT* a Democrat or a Republican
Ending Corruption in Congress is the Single Best Way
to Materially Improve Your Life
entropic3.14decay at optonline2.718 dot net; remove pi and e to reply--ie,
all d'numbuhs
"Juggernaut" wrote in message
ups.com...

Goedjn wrote: " Do you feel like telling us what your objective is,
or should we just guess? "

Well smart ass - if you read the subject line you could have deduced
that i wanted to LEVEL the section of uneven floor.