I ordered a bath waste ( item number 10262) from www.bes.co.uk and it arrived
today just after the bath arrived .

I tried the overflow part on the bath .It consists of the cover and two thin and
one thick washers .

Using all three washers ,one thin one inside the bath and the other two at the
back it was impossible to screw the two parts together .Using the two thin
washers it could be screwed together but not without some difficulty. It got to
acertain tightness and then went loose again .The bore of the overflow
connection on the back of the bath is a good bit smaller then the hole in the
bath . Screwing it together away from the bath it tightens up fine .

Are these sizes not standard .?

Is it going to be a case of fitting the overflow with the assistance of some
silicone to keep it retained and leak free.


Stuart