Martin Bonner wrote:
Following on from an earlier message thread, can anyone recommend a
good biscuit jointer?

For the task in hand, I just need to be able to joint boards edge to
edge which means I think all I need is a jointer that will reliable
cut a slot that is
- parallel to the top surface (or square to the edge)
- a consistent distance from the top surface

Any other features that are likely to be of use?
Any features that just get in the way and waste money?
Best value for money?

I bought a Ferm one from Screwfix about 18 month ago. Don't use it that
much TBH but it seems fine to me - similar aplication to yours.


--
Dave
The Medway Handyman
www.medwayhandyman.co.uk
01634 717930
07850 597257