hard to move belt on craftsman drill press
I have a Craftsman Benchtop 10" drill press (pretty new if that has any
effect on your answer). When I attempt to change the speed by moving the
belts, it is quite a struggle. I loosen the knob and push the motor forward
(doesn't go very far) and have to really work the belt to get it off.
Usually I end up crunching my fingers a few times between the belt and the
spindle.
Is there a trick? Will this loosen over time? An easier kind of belt?
Any help is greatly appreciated.
Jordan
Remove _nospam from my email to email me directly......
|