"Ancient_Hacker" writes:

Tim Sampson wrote:
Hi Folks

I've got myself in a right pickle trying to fix the broken cable on my
TFT monitor. It's a Mitac MT-15AX1-NBU. I need to replace the 15 pin plug
but due to an unfortunate turn of events, I don't know what pins some of
the wires should solder to.

dunno why you're getting read and fuzzy. Did you connect the ground
shields on the coax to pins 5-6-7-8-10?

If that still doesnt work, you can get vga cables pretty cheap on eBay.

Not if it's a cable hard-wired into the monitor!

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.