On 23 Oct 2006 07:02:00 -0700, "Mark Trueman"
wrote:

|Hi there,
|
|I am looking to buy the following from the usa
|
|http://www.azusaeng.com/wheels/whls8a.html
|
|The problem i have however is with bearing sizes. The O/D of the
|bearings required for this wheel are 1+3/8 of an inch, which is 34.925
|mm. I can source bearings in this country with an I/D of 17mm, which is
|required for my application, however, the OD of the UK bearing is 35mm.
|
|
|The question is, will a 35mm bearing fit in the hub that is built to
|accept 34.925mm bearings? Will it just be a bit of a squeeze to get the
|bearing in? Will there be any problem with the bearing if it is
|slightly compressed?

Your local bearing shop can get whatever you want, metric or imperial.
--
Dave Fawthrop dave hyphenologist co uk Google Groups is IME the *worst*
method of accessing usenet. GG subscribers would be well advised get a
newsreader, say Agent, and a newsserver, say news.individual.net. These
will allow them: to see only *new* posts, a killfile, and other goodies.