I have a welder on my little vertical saw and it does a good job after
practice, especially drawing back the weld. However, I have found that it
is cheaper to get the blades welded from my supplier at $2.50 per weld and
they stock the blade stock. I get charged the same per foot if I buy 100'
or have them weld-up finished blades. So, for $2.50 per blade, is it worth
your time? Or, do you do some internal cuts?


"Mark" wrote in message
...
An old PM article uses a homebrew transformer similar to the one I
wound in 10th grade for my from-scratch soldering gun. A long time ago!

I recall someone's suggestion that a "real" soldering gun could form
the basis for a spotwelder - all I'm interested in doing is making
better bandsaw blade joints than my crappy Silver soldering has
produced to date. My bandsaw only has 10-inch wheels, and I haven't
been able to make a lasting joint in HSS - 1/2 inch stock....

Before I rush out and buy a cheap soldering gun, has anyone done this
successfully?

Thanks / mark