Holding threaded rod in a vise
"Matty F" wrote in message
oups.com...
What is the recommended way to hold threaded galvanised steel rod in a
vise so that the thread is not damaged?
The rod needs to be cut with a hacksaw. Actually it will be cut in a
metal bandsaw, but it's the same question as the bandsaw also has a
vise.
I believe I have invented the best way, but I was wondering if there
was a "proper" way that a perfectionist engineer might use.
In view of the high volume, you need something faster than winding nuts on.
For a volume job like this I would use two nuts cut in half that are welded
to disposable vice jaws, that way you have a fast way to clamp without
damage to the threads, you would also be likely to incorporate a length stop
at the same time.
Mrcheerful
|