Todd H. wrote:

"Toller" writes:


"ap" wrote in message
roups.com...

Hello,
After shopping around much, purchased a nighthawk digital for $33 from
wal-mart.
These are expensive and I'm wondering if the best placement would
be high in the hallway near the bedrooms. There are 3 bedrooms that are
occupied.


I put mine in the basement near the floor. Only my water heater or furnace
could make CO, and I would rather find out about it when there was CO in the
basement than when it hit the bedrooms.

No alarms in 5 years.


For what it's worth, the basement and "near the floor" and "in the
actual furnace room" are all among the "bad idea" places listed in the
Nighthawk manual.

Part of the reason is that CO is slightly lighter than air and tends
to rise. The other part is that if yu have a cracked heat exchanger
and conditions that are putting CO into your ductwork, a detector on
the floor of your furnace room will quietly assume all is well because
it'll never know.

--
Todd H.
http://www.toddh.net/
Hi,
I read somewhere detector located in the bottom level of house did not
do much in actual CO poisoning case. CO and CO2 are two different thing.