In article ,
Tom Gardner wrote:
I need the best, cheapest way to cut a 1-1/2" wide by 3/64" deep slot
across a KD Beech block that is 2-1/4" wide. I need to do at least
2,000/day. I already do this but I won't say how as not to influence you.
We are trying to come up with a better, faster cheaper way.



3/64" deep? I'm curious, why do you need to cut this (I hesitate to
use the word) "slot" anyway?

If I had to do 2000 of these a day, I believe I'd take this old 4"
jointer I have but seldom use, and and grind an old set of knives to
give the 1.5" width. Cut the blocks to length afterwards.

--
No dumb questions, just dumb answers.
Larry Wasserman - Baltimore, Maryland - lwasserm(@)charm(.)net