I once saw a friend make a super srarp knife just for this sorth of
thing, his was only 1" wide trench, and he had to work it in 6 inch
sections, but it was clean and quick.

Empressess #124457


The best Games


a href=http://www.gamestotal.com/Multiplayer Online Games/a a
href=http://www.gamestotal.com/Strategy Games/abra
href=http://uc.gamestotal.com/Unification Wars/a - a
href=http://uc.gamestotal.com/Massive Multiplayer Online
Games/abra href=http://gc.gamestotal.com/Galactic Conquest/a -
a href=http://gc.gamestotal.com/Strategy Games/abra
href=http://www.stephenyong.com/runescape.htmRunescape/abra
href=http://www.stephenyong.com/kingsofchaos.htmKings of chaos/abr




bryanska wrote:
Hey,

Does anyone have any ideas on how to cut a 3-inch wide and 1-inch deep
trench into the face of a panel of EPS foam insulation?

It should travel vertically up and down the 8-foot high face.

Any ideas welcome.