Jeff wrote:

I have a Briggs OHV (Intek?) snow engine, Model 12c113 series. The
engine doesn't have a speed control, that is the engine is either
running full tilt or it is off. (I'd say throttle, but I believe all
engines have a throttle, they're connected to the governor, and a speed
control would manipulate the governor, not the throttle directly.)
Other 12c000 engines DO have an adjustable speed control and indeed
there is blank plate on mine where it would be in other versions.

My engine doesn't seem to like to go to full power immediately when it's
cold, and I'd like to run the engine at idle speed for a few minutes
after use to melt off any snow before shutting it down. Having a remote
cable to the handle isn't important.

How hard would it be to add a speed control lever to the governor on my
engine? I believe the part number I'd need is Briggs and Stratton #
691028 .

Thanks!


I'm not familiar with that particular engine, but if it follows previous
designs and there's a coil extension spring visible in or around the
throttle linkage, what you'd do is rig something to change the position
of the "fixed" end of that spring.

Moving that end in a direction which lessens the tension in the spring
should slow down the engine's overned speed.

HTH,

Jeff

--
Jeffry Wisnia
(W1BSV + Brass Rat '57 EE)
"Rudeness is the weak man's imitation of strength."