View Single Post
  #3   Report Post  
Posted to alt.home.repair
Lawrence Lawrence is offline
external usenet poster
 
Posts: 651
Default Kitchen cabinet makeover


Malcolm Hoar wrote:
My kitchen cabinets are about 15 years old. The frames and doors
are solid wood (oak?) although the end panels appear to be veneered
plywood. They were apparently finished with an oil-based poly and
do have an ambered appearance.

The doors are in pretty good shape -- a few have some grease marks
and water stains mainly along the top edge. In a few cases, the
old poly has flaked off.

The frames are structurally great but the finish is in poor shape
with a lot of flaking.

I'd like to give them a makeover but stripping or sanding the
entire surface area down to bare wood is daunting. Therefore,
I'm considering a hybrid approach and would welcome any comments
or suggestions.

Frames:
1. Clean to remove all grease
2. Sand to bare wood
3. Stain? A quick test (few square inches) suggests this may
not be necessary for a decent match. But perhaps it will
help the appearance and give a better bonding surface for
the poly?
4. Apply 3 coats of Minwax Polycrylic Gloss
5. Lightly sand -- I'll probably use one of those scotchbright things
6. Apply 1 coat of Minwax Polycrylic Satin

Doors:
1. Use a "deglosser" product to clean/etch the surface
2. Apply 1 coat of Minwax Polycrylic Gloss
3. Lightly sand -- I'll probably use one of those scotchbright things
4. Apply 1 coat of Minwax Polycrylic Satin

An oil based poly may be slightly more durable but the Minwax
product seems almost as good and a *lot* more convenient.

Obviously, there's potential for a mismatch between the doors and
the frames. I can certainly live with that if it's minor.


How many cabinets are there?? Your idea to sand down to bare wood
sounds problematic.
Sanding is an unpleasant job and worth avoiding. For you to sand
down to bare wood will be more difficult than you think. It is
possible you may never be able to sand every bit of the paint off to
the degree that you wil find it to be stainable wood. It is more
likely for you to get it off if you use a paint stripper.

Even then, you may be dissapointed with what you find underneath.
Keep your options open until the stripping and sanding is done. thant
way you can decide, if necessary, to just paint them and call it good.