In article . com,
Bookworm wrote:
Hi Folks, A Quickie [I should be so lucky!!]
I have just installed a new wash hand basin with 10mm tails. The
resultant flow is [putting it mildly] very poor.
I was thinking of changing the connections to the hot water cylinder
from an indirect to direct feed. Can I do this to my existing cylinder
or, because of the increased pressure will I have to fit a new one.
Thanks for your input

Its the 10mm tap tails that are your problem. No way round that other
than to fit different tap.

I've got 10mm tails to both basin and bidet in my bathroom with only the
basin cold fed off the mains. And I'd describe the flow as adequate -
surely you don't want high pressure from either splashing all over the
place?

--
*Two wrongs are only the beginning *

Dave Plowman London SW
To e-mail, change noise into sound.