DIYbanter - View Single Post

Doug Miller

In article , lid wrote:

I nicked the blades very early, running construction lumber through it for
"practice". The knots in the SPF really dinged the blades pretty well. I was
able to offset the blades a tad to minimize the ridging on stock for a while.
When there were too many nicks to get away with that, I turned them around,
one at a time, and repeated that process. I have a new set of blades ready to
install. I think I'll need to do that before I start my next project.

Before you do that... try honing the ones you have now. I'm on (I think) the
fourth re-sharp on the *first* set of blades in my DW735 that I've had for
over two years.

--
Regards,
Doug Miller (alphageek at milmac dot com)

It's time to throw all their damned tea in the harbor again.