John Rumm wrote:
wrote:

Hi John, I have noticed a problem, the centres of the joists are too
close together to allow acces with a drill !! I take it drilling at an
angle is a no go, as compared to drilling at 90.


Buy a cheap[1] spade bit, and hacksaw it down so that it is just a tad
over joist thickness. In an odinary mains drill or a cordless drill it
normally then fits between the joists.


[1] You could also use a decent quality spade bit, but then you may need
an angle grinder to cut off the shank as the metal will be harder!

--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/



Nice idea ! I'll give that a go first, definateley the cheaper option
:-)