Toller wrote:
I need to make a cut that might go through 1 or 2 little nails.
I am not sure yet if I will be using a TS or a circular saw, but I think
either should go through an 18 gauge nail easily enough, shouldn't it?

I have accidentally gone through finishing nails before, once damaging the
blade, but those are a lot bigger. Whatcha think?

Is this for a furniture piece? Can you get by with using a cheapo $10
blade? Can you create new pieces? Is this plywood or solid wood..
because a cheap blade might splinter your plywood veneer.

I've cut through finishing nails several times while trying to salvage
trim, but I used an inexpensive blade. A carbide type blade will go
through, no problem. I wouldn't risk a $100 blade though.