On Sat, 12 Aug 2006 21:17:04 GMT, Speedy Jim wrote:
an_Musicant wrote:
:
:SNIP
:
: Yeah, some kind of flex tube would work, I suppose. Maybe I'll do that.
: I'm afraid to crank on the nut at the wall in that the drain pipe could
: snap or crack.
:
:
: There is a fix meant for just this situation.
: It's called a "Repair Trap".
:
http://www.doityourself.com/invt/6852578
:
: You don't need to disturb the connection in the wall.
:Just saw cut the tube out of the wall to the length
:needed to mate the Repair Trap to the basin tailpiece.
:
: Use the finest tooth hacksaw blade so as to create
:minimal stress on the existing work.
:
: Although the repair trap has rubber or plastic compression
:seals, I've found it helpful to apply a bit of silicone caulk
:as well to keep the joints in alignment afterward.
:
: If the trap will be exposed, this repair will look "correct"
:rather than gimmicky.
:
:Jim
I gave it a big try yesterday to twist off that nut. It's a big nut, 2"
hex with a 1 1/4 inch hole in it, aluminum. I had a parallel face wrench
(I think it's a monkey wrench? Ford), and I had a pipe on it's handle
and pounded it many many times with a sledge hammer and I couldn't get
it to loosen. I found a wrench at a hardware store that would fit the
nut, but didn't buy it. I was thinking of cutting it off. A tool lending
library here opens tomorrow and I was going to wait and ask them if they
have a way of loosening the nut.
Today, I decided to give another try to twisting the pipe within the
nut. Grabbing it with leather gloves, I detected some play and I worked
it loose! I could slide it in or out, and I've managed to get it in the
correct position. I had a devil of a time getting the trap to stop
leaking. When I finally got that done I found that the tail piece in the
pop-up assembly was leaking water where it meets the part above it!
Rats!! I took out the pop-up assembly and applied two layers of
contact cement to the joint, figuring it will stop the leak. The water
coming out is obviously not under much pressure. After applying the
first coat of cement, I got the idea that I could have sweated the joint
with solder. I think the cement will stop that leak. It's not much, just
a few drops, but I want it to be perfect.
Dan
PS I think you are talking about a compression join with rubber and a
couple of hose clamps, or similar, right Jim? I had that idea too, but
decided that was plan B or C.