Biscuiting a miter joint?
"Swingman" wrote in message
...
"Toller" wrote in message
I am not thrilled about the recutting my slots, as they are likely to end
up
a bit wider than I would like; maybe I can get away with just deepening
one
side?
Lay some 80 grit sandpaper on your workbench, rub the edge of a biscuit on
it until, when placed in the slot, the gap disappears.
Excellent idea! Why didn't I think of it?
Anyhow, the gap dissappears with the sanded biscuits, so all is well.
Now the only issue is whether I should add a third biscuit in the middle
that is cut deeper.
|