"John" wrote:

Could anyone confirm whether this would be OK or not please?

I want to put my fridge, my freezer, boiler and a TV aerial distribution
amplifier on a non-RCD protected circuit. My (unless you tell me otherwise)
intention is to run from the CU to the freezer (approx 4.0m) then over to
the other side of the room for the fridge (4.2m), then up into the loft for
an FCU (fused at 3A) for the boiler (about 10 or 11m). Whilke it's up in the
loft, it may as well feed the aerial amp that I'll be putting up there.

All in all, a radial circuit of maybe around 20m in total - OK to use 2.5mm
T&E?

Assuming you are intending this to be a new circuit fed from a 20A
MCB, then this is fine.

I would label the sockets for the fridge and freezer clearly, to
reduce the risk of somebody assuming that they are isolated with the
rest of the room. Make sure you have a clear label at the consumer
unit too.

To be pedantic you probably need to label the sockets are being "not
for outdoor use" if they are somewhere where that's likely to happen.

John
--
John White,
Electrical Contractor