View Single Post
  #5   Report Post  
Posted to alt.home.repair
Steven L Umbach Steven L Umbach is offline
external usenet poster
 
Posts: 15
Default Removing bath tub drain??

Thanks for the tips guys!

I ended up using my Makita cordless reciprocating saw and carefully cut it
on the inside in about three places. Then for the top lip I carefully
drilled a hole to line up with each cut just drilling through the drain and
not into the tub. I used a sharp Milwaukee cobalt drill bit to do that. The
bit size was around eight of an inch. Then with a screwdriver I was able to
pry it out in pieces. When I was done I did noticed that I must have chipped
a very small sliver size piece of finish from the tub with black showing
through at about the size of a pin hole near the drain - damn. Oh well the
tub is in good shape but does not look like new. I made sure that area was
clean and dry by swabbing it and using a hair dryer on the area. Since the
tub is white I just put a dab of GE Silicone II on that spot and will let it
dry for at least 24 hours and keep an eye on it to make sure it stays. That
stuff is pretty tough and I just want to keep it from rusting and growing.

If I was going to do it again I would make sure I used a piece of plywood or
such to support the reciprocating saw base on while cutting. I though I was
being careful enough but I think that is how the very minor chip happened.

Steve


"Steven L Umbach" wrote in message
. ..
The wife wants me to replace the old pop up drain in the bathtub in the
kids bath that looks like hell from years of my son pouring Liquid Plumber
into the tub when stopped up. It however drains well and does not leak.
The problem is that the built in strainer has rotted out and there is only
a single nub left that sticks out about 1/8 inch - not much to grab onto.

Sure I could hack it out but I don't want to damage the tub around the
drain opening or damage the plastic plumbing because if I do I will have
to cut a hole in the kitchen ceiling to access the plumbing. Then If I do
that I will have to also repaint the whole kitchen/breakfast area ceiling
after repairing the drywall.

I do have a Makita 9.6 V compact cordless reciprocating saw with a short
metal cutting blade that I am thinking of using to try slowly and gently
cut the drain in two spots on the inside to then try and remove it though
I might also cut into the drain pipe slightly [the threaded area] and am
not sure if that will be a problem or not. Does that sound like a god way
to go or does anyone have any other ideas other then leaving it be as is?
Thanks

Steve