Eric in North TX wrote:
Ok, you don't say for sure, but I'm assuming you replaced it. If it is
like mine, it has a knurled knob on top. There is an adjustment under
that, adjust it a little higher (tighter, clockwise I think) and see if
that helps.
Hi Eric
The valve I am working with is not for a water heater as someone
mentioned above but for a well tank. The valve is quite smaller than a
hot water tank valve and very different. It basically is just a brass
fitting with spring inside(visible) and the opening is like a garden
hose fitting that is where the drip comes from. Dont think there is an
adjustment on this one. THere is s small piece size of dime that is
threaded in but doesnt look like it should be messed with. I can see
the explosion now hahaha
Should have seen me when I took it off. Turned off the 220v shut the
water off. Only thing is didnt think about the pressure tank needless
to say I took quite the shower and had quite a mess to clean