DIYbanter - View Single Post

wrote:
I was contacted by Sanyo asking if I would make a service call 7 miles
from here to replace an "AV board" in the above model flat screen set.
The customer is to remove the set from the wall. Sanyo will provide the
board. They tell me there are about 40 screws to remove the back of the
set and the then its just a matter of unplugging connectors to replace
this board. Apparently this is a common problem with these sets?
According to them the job should take about one hour, ( I don't know
about that), and that the going rate they usually pay technicians for
this service is 135.00. Is anyone familiar with this job and does this
seem fair? It just seems a bit light for a service call and an hours
labor on a set like this, but I'm not sure. Thanks very much. Lenny
Stein, Barlen Electronics

Even if you lose money on this first job, surely for the experience it
will pay off.
You get on their service list, and will be ready for the next job,
which then you will be sure what you are up against.