Apologies if this is really stupid:
I just received my new Jet mini lathe and Pinacle tools from Woodcraft.
I have turned only once, many years ago. I honed the tools with some
rouge and then used the lathe. My cuts are really really rough, and I
think I'm just ripping the wood. How clean should I expect my cuts to
be? Does the wood species matter in this? Is it that my tools are
dull, or is my cutting technique poor, or both?
Thanks,


I'm going to guess that you are using your chisels and gouges as if they were
scrapers. That will produce a rough finish and is the most common mistake
beginners make. It is true that Scrapers are used with the tool held
horizontally, so the cutting edge scrapes along the spinning wood. But, Chisels
and Gouges are held with their handles dropped, pointing downwards. This causes
the cutting bevel (the underside portion you honed) to rub on the wood,
presenting the cutting edge to the wood.

Try this. Get a 2x4 and put it in a vise or clamp it to a table. Now, pick up
your sharpened gouge and make a cut in the wood. Notice how you instinctively
move the handle from vertical to an angle matching the cutting angle? That's
the trick! It's just a little trickier with spinning, round wood, but the idea
is the same.

I suggest finding a local turner to show you the basics, or get one of the
turning videos. Dan