"Dave Plowman (News)" through ahaze of senile
flatulence wrote in message ...
In article ews.net,
Doctor Drivel wrote:
IME for waste pipe a hand saw is *much* better, use a mitre box if
worried about squareness. Give it a try on an offcut...

With solvent weld you can cut it with near anything since the solvent
will
dissolve any raggedness round the cut.

Richard Cranium here is at it again.
He would leave burred edges on the
inside of drain pipe.

Oh, *I* wouldn't. I do things properly.

Richard, you can't do things properly. That is a known fact.