John wrote:

I am going to be painting some steel motorbike bits with smoothrite
after a good wire brushing. Is there any advantage/disadvantage using
one of thier primers or should I just go onto the bare metal.

Also, is the Spray Smoothrite as good as the brush on type.
Regards John

I've found that Smoothrite can crack off thinner steel in flakes, if
impacted (this was on a Landrover chassis, 2mm steel plate). The primer
*may* help, but I've not actually tried.

For thick metal, adhesion has always seemed fine without primer IME.

One tip I do have, if the parts are small, and SWMBO is out, is bake them in
the oven at about 80-100C give or take for a couple of hours. Open all the
doors and windows, it is a tad smelly - but the hammerite will finish up
hard as nails.

Cheers

Tim