On Wed, 14 Jun 2006 13:23:40 +0100, PM wrote:

A couple of questions regarding extending gas pipework:

1) It is illegal to run gas pipe in a cavity wall because of the possibility
of gas build-up, does this mean it is preferable where I have the choice to
run gas pipe along a wall rather than under floorboards?

2) How do I clear the existing pipe of gas before soldering the new pipe on?
The pipe comes down from the meter, under the floor (presumably horizontally
but I've got no way of telling) and then up in a cupboard which is where I
will be making the join. So I would imagine most gas will escape once I open
up the old pipe - but with things like this it is best to make sure! Should
I open up the test nipple at the meter to aid dispersion? I don't have any
gas analysis devices.
N.B. I am fully aware of the need to purge air from the new installation.

As always if you need to ask you probably shouldn't be doing it...

1) Through cavity is fine but there are extra rules. See BS 6891

2) No need to purge gas from the pipes. You will need to seal the meter
outlet if working within 2m of the meter. The gas can only burn if comes
into contact with air. Even when unsoldering fittings the most you even
get is a small flame which goes out in a few seconds.



--
Ed Sirett - Property maintainer and registered gas fitter.
The FAQ for uk.diy is at http://www.diyfaq.org.uk
Gas fitting FAQ http://www.makewrite.demon.co.uk/GasFitting.html
Sealed CH FAQ http://www.makewrite.demon.co.uk/SealedCH.html
Choosing a Boiler FAQ http://www.makewrite.demon.co.uk/BoilerChoice.html
Gas Fitting Standards Docs he http://www.makewrite.demon.co.uk/GasFittingStandards